6 Airplane Crashes Caused By ATC Errors | Part – 2

6 Air Accidents Caused By ATC Errors | Part – 1

4. Importance of Atmospheric Pressure: Kharkiv Accident (1975)

Pilots while landing or departing are given a value of Atmospheric pressure in terms of QNH or QFE by Air Traffic Controllers. Atmospheric pressure value allows pilots to accurately know aircraft height above sea level or terrain. If a wrong QNH/QFE is given, then the altimeter will give pilots an incorrect altitude read out.

For example, it is possible that the onboard altimeter is showing that the aircraft is at 1000 feet above terrain but in reality, it might be at an altitude of 500 feet. So atmospheric pressure plays an important role especially while landing when the altitude error can cause aircraft to hit the terrain and end up in a disaster.

That day, it was an Aeroflot Airlines Antonov-24 aircraft flying from Rostov on Don to Kharkiv. While at an altitude of 4800m, the crew requested further descent. ATC gave its descent to 2400 meters. After reaching 2400m, the crew again requested further descend for landing at Kharkiv airport. At that time atmospheric pressure was 737 but ATC by mistake announced 757. Pilots also read back 757 that ATC did not hear back properly and did not rectify it to 737. So the aircraft system was now showing the wrong altitude because of a wrong value of atmospheric pressure and it was flying at a lower altitude than the altitude shown by the equipment. ATC gave clearance to descend to 400m at the crew’s discretion. When the aircraft was 15 km from the airport, ATC gave them further descend to an altitude of 300m. After some time of this clearance, the aircraft hit the terrain and crashed, killing 19 of 50 people on board.

So this crash was due to the wrong value of atmospheric pressure passed by ATC to Pilots. But this could have been averted had the ATC heard back properly the value (757) of atmospheric pressure confirmed by Pilots. Also, pilots did not react to the altimeter warning 50m above the first barrier.

5. ADC Airlines Flight 86 Crash (1996)

This Nigerian domestic flight was operating between Port Harcourt to Lagos on the day of the collision. This Boeing 727 of ADC Airlines was at flight level 240, under the control of Lagos ATC at the time of the collision. Pilots of ADC flight requested descend which was delayed by ATC as there was another aircraft (ELF Petroleum Business Jet) at flight level 210, which was traffic for this flight. Due to this ATC was unable to give them descend. At the same time, there was another Triax aircraft flying at flight level 160.

After some time when the controller finally cleared the ADC flight to descend, he thought he had cleared to aircraft to FL100 at an earlier stage, but the aircraft was still flying at FL240. So ADC aircraft started to descend from Flight level 240 with potential traffic at flight level 160. While passing through flight level 160, TCAS warning came as there was Triax Aircraft at the same level (flight level 160).

The flight crew took evasive action but in doing this maneuver the aircraft rolled to an excessive bank angle and the crew lost the control of aircraft. It was falling with a speed of sound towards the ground. After a few seconds, the Aircraft got crashed near a place Imota, killing all 143 people on board.

The primary reason for this fatal accident was a wrong assumption and lack of situational awareness of the Air Traffic Controller.

6. Gol-Embraer Mid Air Collision 2006

 On September 29, 2006, A business Jet (Aircraft Type Embraer Legacy 600) was flying northbound from the Embraer factory in Brazil to Manaus for a delivery flight. Gol Airlines flight 1907 was flying southbound from Manaus Airport to Rio De Janeiro. Both Aircraft were flying at flight level 370 which went unnoticed by Brazilian ATC. At 1648 local time both aircraft collided over the Brazilian state of Mato Grosso. A business jet winglet split the left wing of Gol’s Boeing aircraft which caused excessive roll of the aircraft which disintegrated and crashed killing all 154 people on board. Embraer aircraft and its occupant were lucky enough to land safely at a Brazilian air-base.

10 Worst Plane Crashes In History

In the investigation, it was found that both aircraft were assigned the same flight level at the same point of crossing. Although as per the flight plan of Embraer aircraft, after a certain point, it was supposed to fly at flight level 360 but Air traffic controller did not instruct it to descend to flight level 360 assuming that the Aircraft was already at flight level 360.

The second point was that Embraer aircraft pilots were unable to make contact with ATC for almost 57 minutes. Had they contacted ATC, it might have been possible that ATC could have rectified his own mistake of assuming the aircraft to be at flight level 360 instead of its actual level i.e. Flight Level 370.

The third point was that the Transponder of Embraer aircraft was accidentally in a switch-off mode which went unnoticed by ATC as well as the pilots of Embraer aircraft. Because of this none of the concerned aircraft got any TCAS warning regarding imminent danger and kept flying towards each other, eventually colliding over Amazon.

So Air Traffic Controllers’ errors can be fatal for aircraft and their occupants. They are required to be well-equipped as well as almost hundred percent correct all the time. Here, we need to understand that Air traffic controllers are also human beings and they can contribute to the creation of accidents for various reasons such as loss of situational awareness, unintentional wrong information passed to pilots, misinterpreting the crew’s requirements, or due to adamancy as well.

They need to be provided with more sophisticated systems with the possibility of more control and prediction of individual decisions. Another important factors that can minimize ATC errors will be the provision of adequate manpower at all the ATC stations which will help in the reduction of the workload of Controllers.

0 Shares

Did You Find This Post Useful?

Subscribe Below And Get Such Posts into Your Inbox

About The Author

9 thoughts on “6 Airplane Crashes Caused By ATC Errors | Part – 2”

    1. sudhir sheoran

      There is no such priority. Only your knowledge, confidence and communication skills will have priority.

Leave a Comment

Your email address will not be published. Required fields are marked *

0 Shares
Share via
Copy link
Powered by Social Snap